How to Make a Multi-Coloured Lino Print: A Vibrant Step-by-Step Guide
Creating a multi coloured lino print is a rewarding process that combines precise carving with a vibrant ink application. This technique allows you to build an image layer by layer, using different colours to add depth and personality to your final piece. The key to success lies in understanding how to register each colour accurately so that the layers align perfectly, resulting in a clean and professional-looking print.
Understanding Reduction Lino Printing
The most common method for achieving a full colour lino print is reduction lino printing. Unlike methods with separate blocks for each colour, reduction printing uses a single piece of lino. You begin by carving the lightest colour and printing it across the entire surface. With each subsequent colour, you carve away more of the lino, meaning you are physically destroying the block as you progress. This method is incredibly economical with materials but demands careful planning, as you cannot go back once a section is carved away.
Planning Your Colour Separation
Before you touch a cutting tool, meticulous planning is essential. You need to deconstruct your design into separate colour layers, determining the order in which they will be printed from light to dark. Create a detailed sequence plan that outlines exactly which areas you will carve down for each colour. Consider the contrast between your colours; a light base colour printed first will allow subsequent darker colours to sit beautifully on top, creating richness and depth in the final composition.
Preparing Your Materials and Workspace
Gather high-quality lino blocks, sharp carving tools, a rolling pin or brayer, water-based relief inks, and suitable printing paper. A glass or acrylic sheet is necessary for rolling out the ink, and you will need a surface for mixing colours. Ensure your workspace is well-lit and organised. Using a registration system—such as a taped-down registration board—will be crucial for multi-coloured prints. This system keeps the paper and lino block in the exact same position for every single layer, preventing the image from shifting and ruining the alignment.
Mixing and Applying Ink
To achieve consistent and vibrant results, you must master ink preparation. Roll a small amount of ink onto your glass surface and gradually add fresh colour to create your desired shade. Mix thoroughly until the colour is uniform. When applying the ink to the lino block, use your brayer to roll the ink in a smooth, even motion. You are looking for a ‘track’ or ‘bacon’ consistency where the ink covers the surface thinly and evenly without piling up in the carved grooves.
The Carving and Printing Process
Start your print by carving the areas of the block that will remain the base colour, effectively removing everything that should be blank paper. Ink the the entire surface, place your paper carefully, and run it through the press or rub the back firmly with a spoon. Once dry, move to your next colour. This is where your planning is tested: you must carve away the parts of the lino that were inked in the previous layer, leaving only the shapes for the new colour. Each stage requires patience; rushing the carving can lead to slips that compromise the entire design.
Registration and Layering
Registration is the single most important factor in multi-coloured printing. Misalignment turns a beautiful piece into a messy accident. Use pins or tabs on your registration board to hold the paper exactly in place. When you lay the inked lino block onto the paper, align it with these guides and apply even pressure. Lift the paper gently to reveal the layer beneath, checking for perfect registration before proceeding to the next colour. This meticulous attention to detail ensures that your colours sit exactly where you intended, creating a cohesive and polished artwork.
Troubleshooting and Finishing
Even experienced printers encounter challenges. If your colours are muddy, you may be over-mixing your inks on the block or printing too many layers, which can dull the vibrancy. If you see unwanted smudges, check that your ink is dry before registering the next layer and ensure your carving is deep enough to prevent ink from bleeding under the edge of the block. Once your final layer is dry, you can mount the finished print on archival quality card or leave it as a delicate original piece, ready to showcase the intricate work involved in creating a stunning multi coloured lino print.