How to Replace the Battery in a Bose SoundLink Color II: Easy Step-by-Step Guide
Replacing the battery in your Bose SoundLink Color II is a practical way to extend the life of your speaker and save money on a replacement. While the rechargeable lithium-ion battery is designed for longevity over several years of use, all batteries eventually degrade. This guide provides a clear, step-by-step walkthrough to help you successfully complete the swap without damaging your device.
Gathering the Right Tools and Preparation
Before you begin, preparation is key to ensuring a smooth and safe experience. You will need a specific set of tools to access the internal components without causing damage. Using the correct equipment reduces the risk of stripping screws or scratching the durable plastic housing.
Required Items
- Phillips PH1 screwdriver
- Prying tool or sturdy plastic spudger
- Replacement battery (specifically a 3.7V 18650 lithium-ion cell)
- Optional: Heat gun or hair dryer
Power Down and Prepare the Speaker
Start by turning off your SoundLink Color II completely. If the battery is too low to power on, you can still proceed, but be aware the unit will not turn on during the process. It is recommended to let the speaker sit unused for a few hours to allow any residual charge to dissipate, which minimizes the risk of an electric shock during disassembly.
Removing the Outer Casing
The casing is secured with Phillips screws hidden under the rubber foot pads. Carefully pry up each foot to access the screws underneath and remove them. With the screws out, gently separate the top shell from the bottom base. You will need to use your prying tool along the seam, applying steady pressure until the clips release. Heat can be applied briefly to soften the plastic clips if they are particularly tight.
Disconnecting the Old Battery
Once the casing is open, you will see the circuit board and the battery connected by a small JST connector. Before touching any wires, ensure the speaker is fully powered down. Locate the connector on the board and gently lift the black tab on the connector side to disconnect the battery. Avoid pulling on the wires themselves; always handle the connector to prevent damage to the delicate wiring harness.
Installing the New Battery
With the old battery disconnected, prepare the replacement. Match the dimensions and voltage of the original unit, typically a 18650 cell, to ensure compatibility. Align the positive and negative terminals correctly—usually red indicates positive and black indicates negative. Firmly press the new JST connector onto the board, ensuring the tab locks into place securely to prevent a loose connection later.
Reassembling the SoundLink Color II
Place the battery into the cavity and align the top shell back over the bottom base. Press down firmly around the edges, listening for the distinct click of the plastic clips sliding back into place. Reinsert the screws into the foot pads and tighten them carefully. Finally, turn on the speaker to test if the charging indicator appears, confirming that the new battery is functioning correctly.